A
tenoning jig can be an extremely valuable tool at the table saw. Not only does
it provide a carrier for narrow pieces when tenoning, but with the vertical backstop
removed, the jig can also be used for raised panel cutting. The sliding base provides
plenty of range of motion for positioning and locating your cuts, while the large
10" x 10" faceplate provides ample support and clamping area for the
largest of panels.Begin
by adding a Miter Slider to a small Build-It Panel. Place in your table saw's
miter slot and adjust for
a good fit. If the blade tilts right, place it in
the left hand miter slot. If the blade tilts left, place it in the right hand
miter slot. Add a T-Slot Panel Connector to each edge of the panel. Cut the slotted
holes and grooves as shown on the (2) 10" x 10" x ¾" thick
panels. If you are using MDF you can cut the grooves with a 3/4" straight
bit at your router table. If you are using plywood, remember it is often slightly
undersized so an undersized "plywood bit" is recommended for the cuts.
The depth of cut should be 1/4" and the fence to bit distance is 5/8"
for all of the grooves. Before gluing up the panels and braces, drill the (2)
5/16" dia. holes
in the faceplate panel. Make the (2) edge guides as
shown. Attach the first edge guide to the Build-It Platform and square it to the
edge of the platform. Slide the right angle assembly up against the edge
guide
then add the other edge guide. Add the backstop to finish.
